Skip to main content
Skip table of contents

ETHERNET HARDWARE INSTALLATION AND LAYOUT

NOTICE

HAZARD OF EQUIPMENT DAMAGE

Do not plug a CANbus Terminator into the Ethernet Port of a LYNK II Gateway Device.

Failure to follow these instructions may result in equipment damage.

Ethernet port is enabled to remotely configure, monitor, and troubleshoot Discover Batteries through LYNK CLOUD. Refer to CONFIGURING LYNK CLOUD REMOTE MONITORING to set up the LYNK II to work with LYNK CLOUD.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close