Skip to main content
Skip table of contents

CAN HARDWARE TERMINATION AND CAN OUT PIN CONFIGURATION

LYNK II CAN Termination

NOTICE

DISCONNECT POWER

Disconnect power and all connections to LYNK II before attempting to configure header jumpers.

Failure to follow these instructions may result in equipment damage.

Jumpers are used to configure termination for the AEbus and LYNK Networks, and the CAN Out PIN assignments. Follow the instructions in the LYNK II Installation and Operation Manual (805-0033) to access the configuration header board and jumpers.

Detailed pin configurations are included in the LYNK II User Manual but are repeated here for convenience.

NOTE

LYNK II terminates the AEbus and LYNK Network by default. Do not remove the termination jumper inside LYNK II unless instructed to do so by Discover Energy Systems.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.