Skip to main content
Skip table of contents

Installing an External Power Source

LYNK II can utilize one of three power sources. LYNK II will automatically use the highest priority source if all three power sources are connected.

Connect LYNK II to one or more of the following:

  • A 13-92 VDC power supply (or battery) connected to the Phoenix connector pin 7 (GND) and pin 9 (Vin).

  • The AEbus Port or LYNK Port of a Discover lithium battery.

  • A USB device (relays will not function with USB as the only power supply).

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close