Skip to main content
Skip table of contents

INSTALLATION

The following instructions describe how to connect single or multiple batteries in parallel to a DC load.

warning.png

ELECTRIC SHOCK AND FIRE HAZARD

  • This equipment must only be installed as specified.

  • Do not disassemble or modify the battery.

  • Do not touch exposed contents if the battery case has been damaged.

  • There are no user-serviceable parts inside.

Failure to follow these instructions may result in death or serious injury.

NOTICE

EQUIPMENT DAMAGE

  • Some chargers and inverters support temperature-compensated charging. Disable temperature-compensated charging on the charger or inverter.

  • Do not use or install a battery temperature sensor.

Failure to follow these instructions may result in equipment damage.

NOTE

It is the responsibility of the installer to ensure that all applicable installation requirements and standards are met.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.

Contact Support Close